A-Bar

I got this stainless A-Bar through a fellow forum member who bought it but then decided to get a full-size bull-bar. It is 2" tubular stainless steel and came with all the required mounting brackets and bolts as well as a couple of small brackets on the upper cross-member to mount spotlights if required.

Parts Supplied:

Fitting

Fitting is relatively simple, you just need spanners, a socket set and a 5mm alun key. Just remember not to do up any bolts tight until everything is in place.

The main brackets fit underneath the chassis and longer bolts are supplied on one side as these go through the trail hook:

Support Brackets

There are also two smaller support brackets that attach to the front of the chassis, these are quite awkward to attach to the chassis and requires a normal spanner (socket will not fit):